Heritage Brownstone Brick Wall

Bring the timeless character of city brownstones to your space with a realistic brick-look wallpaper that installs in hours and removes cleanly when you’re ready for a change. This removable design is renter-friendly, PVC-free, and printed with eco-friendly, water-based inks for a beautiful finish you can feel good about.

Why you’ll love it

• Authentic brownstone brick pattern adds depth and warmth without the weight or mess of real masonry.
• Removable and renter-friendly—peels off cleanly from most properly prepped walls.
• PVC-free material printed with eco-friendly, water-based inks.
• Matte, glare-minimizing surface for a refined look in any light.
• Easy DIY panels: each roll is 24 inches wide and available in heights up to 120 inches.

Sizing and coverage

Each roll is 24 inches wide by your chosen height (up to 120 inches). For a full wall, calculate how many rolls you need:

1. Measure the total wall width in inches.
2. Divide by 24 and round up to the next whole number—this is your roll count.
3. Select a roll height at least 2–3 inches taller than your wall to allow for trimming.

Example: A 120-inch wide wall needs 5 rolls (120 ÷ 24 = 5).

Surface and room suitability

• Best on smooth, clean, primed, and fully cured walls (allow new paint to cure for 30 days).
• Not recommended on textured walls, brick, stucco, or surfaces painted with high-scrub/washable or stain-resistant paints.
• Great for living rooms, bedrooms, offices, and hallways. Avoid direct water contact and high humidity areas.

Installation guidance

1. Unroll and let panels relax flat for 24 hours.
2. Clean the wall with a damp, lint-free cloth and let dry completely.
3. Mark a plumb (vertical) line to keep the first panel perfectly straight.
4. Peel 6–8 inches of backing from the top, align, and apply lightly.
5. Smooth downward with a felt squeegee, working from the center out. Peel more backing as you go—do not stretch the material.
6. Align the brick pattern and butt seams carefully between panels.
7. Trim excess at the ceiling, baseboards, and around outlets with a sharp blade and straightedge.
8. For bubbles, gently lift and reapply; tiny bubbles can be pricked with a pin and smoothed out.

Tip: Install at room temperature (65–75°F / 18–24°C) for best adhesion.

Care

• Wipe with a soft, damp cloth; use mild soap if needed.
• Avoid abrasives, bleach, or solvent-based cleaners.
• To remove, peel slowly from a top corner at a low angle. Warm stubborn areas with a hairdryer on low.

Good to know

• Color may vary slightly between screens and print batches; purchase all rolls for a project at the same time for the closest match.
• Test a small inconspicuous area if applying over specialty paints.