Removable Wallpaper for Effortless, Earth-Friendly Style
Bring the warmth of handcrafted plaster to your space—without the mess. Almond Stucco Textured Wall is a removable wallpaper featuring a soft almond hue and a printed stucco effect that looks authentically hand-troweled while remaining smooth to the touch. Designed for renters and refreshers alike, it installs cleanly, removes easily, and elevates any room in minutes.
Why You’ll Love It
Removable and renter-friendly: Peel, stick, reposition, and remove with minimal residue.
Eco-conscious: PVC-free material printed with eco-friendly, water-based inks.
Premium look, smooth finish: Realistic stucco appearance without bulk or texture.
Custom-fit heights: Rolls are 24 inches wide and available up to 120 inches high for floor-to-ceiling coverage.
Versatile style: Perfect for accent walls, bedrooms, living rooms, entryways, and offices.
Size & Coverage
Each roll is 24 in (61 cm) wide. Choose your roll height up to 120 in (305 cm) to fit your wall. To estimate how many rolls you need, measure your wall width in inches, divide by 24, and round up. Add an extra roll if you want additional trimming margin or pattern alignment flexibility.
Surface Compatibility
Best on smooth, clean, dry, fully cured, non-porous painted walls.
Not recommended on heavily textured surfaces, raw drywall, wallpapered walls, or stain-resistant/low-VOC paints that can reduce adhesion.
Fresh paint should cure for at least 30 days before installation.
Care Instructions
Wipe with a soft, damp cloth; use mild, non-abrasive soap if needed.
Avoid harsh chemicals, bleach, or scrubbing pads.
Do not saturate seams or edges with water.
Installation Guide
Prep the wall: Clean with mild soap and water; let dry completely. Remove switch plates and outlet covers. Mark a straight, plumb line to guide your first panel.
Peel & position: Peel 6–12 inches of backing from the top. Align the panel with your plumb line and tack the top in place.
Smooth it down: Slowly peel the backing while smoothing from the center outward with a soft cloth or squeegee to remove air bubbles.
Join edges: Butt-join subsequent panels edge-to-edge. If bubbles appear, gently lift and reapply—no stretching.
Trim & finish: Use a sharp blade to trim excess at the ceiling, baseboards, and around fixtures. Reinstall switch plates.
Removal: Lift a corner and peel back slowly at a 180° angle. If any residue remains, wipe with warm, soapy water.
Good to Know
Install in a temperature-stable room (ideally 60–85°F / 16–29°C).
In high-humidity areas, ensure proper ventilation and that walls are fully dry before installation.
The design provides a printed stucco effect; the surface itself is smooth.
